Those values are written in by separate gases macro. The basis operation is:
It sets all GWPs to one and calculates the results, pastes this as the unweighted emissions in Upstream Results HHV.
For CO2 it sets all values to zero in the matrix and the difference is pasted in the corresponding section on the Upstream Results HHV sheet.
It then selects a gas, setting it to zero and calculating the results. The difference between the two calculations is the value for the gas that was set to zero and it is pasted in the corresponding section on the Upstream Results HHV sheet.
The macro sequentially steps through each separate gas repeating the process.
I hope this helps.
Regards
Don O'Connor
